Magma Computer Hardware PE6R4 I User Manual

Quick Installation Guide  
Magma  
9918Via Pasar, San Diego, CA 92126, USA  
Phone (800) 285-8990 US, (858) 530-2511 • Fax (858) 530-2733  
© 2008 Mission Technology Group, Incorporated, DBA Magma  
This publication is protected by Federal Copyright Law, with all rights reserved. No part of this publication may be copied, photocopied,  
reproduced, stored in a retrieval system, translated, transmitted or transcribed, in any form or by any means manual, electric, electronic,  
electro-magnetic, mechanical, optical or otherwise, in whole or in part without prior written consent from Mission Technology Group, Inc..  
Limitation of Liability  
Information presented by Magma in this manual is believed to be accurate and reliable. However, Magma assumes no responsibility for its use.  
No license is granted by implication or otherwise to any rights of Magma.  
Magma  
Trademark References  
Trademarks and registered trademarks are proprietary to their respective manufacturers.  
PE6R4-I  
Product specifications and prices are subject to change without notice.  
09-09943-02-A  
Package Contents  
2
Open Enclosure  
Remove the 6 screws that retain the top cover of the expansion chassis.  
(6 locations)  
(1) Magma PE6R4-I chassis  
(1) Magma PCIe Host Card  
(1) PCIe Cable x8 to x4  
(1) Power Cord  
IMPORTANT  
!
Important safety, ESD, and other information on how to use MGMA PE6R4-I are provided in the User Guide.  
Electrostatic Discharge Warning (ESD)  
Perform installation and service of circuit cards with semiconductor devices at an ESD work station and follow  
proper ESD procedure to reduce the risk of damage to components  
Slide the cover  
backwards and upwards.  
1
Install PCI Express Host card and connect cables  
Install the Magma PCI Express Host Card into an available PCI Express slot in your computer.  
HOST COMPUTER  
3
Install PCI or PCI-X cards  
Remove PCI filler brackets for the expansion slot you wish to use in the chassis.  
Install peripheral PCI or PCI-X card into slot connector and secure with  
retaining screw.  
Secure it with retaining screw.  
Connect the x8 side of the iPass cable to the host card.  
x4  
Repeat the process for all other PCI or PCI-X peripherals you wish to  
install in the chassis.  
x8  
HOST COMPUTER  
x8 Connector  
4
Power on PE6R4-I  
Connect the x4 side of the  
iPass cable to the back of the  
PE6R4-I chassis along with  
the chassis power cord.  
Turn the power on using  
the power switch on the  
front of the chassis.Verify  
that the green LED above  
the power switch is on.  
PE6R4-I  
x4 Connector  
 

Land Pride Lawn Mower 55 Series User Manual
Lathem Clock AT MSX User Manual
LG Electronics Cell Phone Chocolate Blue Ice User Manual
Liebert Power Supply SERIES 600T User Manual
Life Fitness Bicycle Recumbent Bicycle User Manual
Magnasonic Flat Panel Television 19605MHD User Manual
Marathon Computer Computer Monitor AACC 2000 User Manual
Melissa Microwave Oven 753 084 User Manual
Mellerware Toaster 24440 User Manual
Metrologic Instruments Scanner MS7120 Series User Manual